AlbertC
Superstar
Dec 5, 2020
- Thread starter BMyers
- Start date
Full Metal Junkie
Active Member
Vertical brick... 
It's almost as if in the situation room they were all like: "This brick is an excellent looking material! In fact, a little too excellent... How do we make it look as dumb as possible?"
It's almost as if in the situation room they were all like: "This brick is an excellent looking material! In fact, a little too excellent... How do we make it look as dumb as possible?"
ProjectEnd
Superstar
I like it. Nice differentiation. Why not?
Orson
New Member
everywhere please
ADRM
Senior Member
AlbertC
Superstar
March 13, 2021
drum118
Superstar
April 10
More up on site
More up on site
ProjectEnd
Superstar
Why are there 6 competing ideas on this thing? RAW is the absolute worst with the 'more is better' design philosophy.
AlbertC
Superstar
April 17, 2021
AlbertC
Superstar
May 29, 2021
drum118
Superstar
May 30
More up on site
More up on site
Towered
Superstar
It looked promising initially, but...
AlbertC
Superstar
June 12, 2021
UtakataNoAnnex
Senior Member
...I'll put it in "It could have been worse" category.
concrete_and_light
Active Member
The front dark grey sections on the second and third levels are wayy bigger and more prominent and heavy feeling than in the rendering. IMO this would be pretty decent if that framing section, which has much worse materiality than much of the rest of the project, didn't become so overpowering. It also got broken up into two sections which makes it even more dominant vs. before it was just one dark grey frame the full width of the building.
One thing I'm wondering though: the bottom layer has small periodic holes in it as if something is going to be affixed to it — like signage or an overhang possibly, but in the render the signage is shown below and there's no overhang or anything that would seem to correspond to those holes.
Perhaps these holes reflect another change and signage will now be up there, or there will be an overhang or some other element there, which I think would help break up the heaviness of it.
One thing I'm wondering though: the bottom layer has small periodic holes in it as if something is going to be affixed to it — like signage or an overhang possibly, but in the render the signage is shown below and there's no overhang or anything that would seem to correspond to those holes.
Perhaps these holes reflect another change and signage will now be up there, or there will be an overhang or some other element there, which I think would help break up the heaviness of it.