zzz
Active Member
Was just downstairs and at 1030PM the gym door is unlocked yet again without requiring the keyfob........
Also seems like the left elevator isn't working again.
Also seems like the left elevator isn't working again.
When is the meeting ?
Was just downstairs and at 1030PM the gym door is unlocked yet again without requiring the keyfob........
Also seems like the left elevator isn't working again.
yeah, 23C is the lowest I've seen it as well. I do like it cooler, but I guess 23C is good for a workout - I wont complain.
Cool air continues to come out while it's @ 23C, so I'm not sure if it's struggling to go lower than 23C or not. Guess we'll see in the next few days as it cools down. I'm happy as long as it's capable of maintaining 23C.
I am assuming the turnover meeting is for electing the board? Not much info on there. I nominate Asmegin and Mark
haha one of us 3 need to be on the board - we all seem to be on the same page.
I don't know why its so difficult for them to program the keyfob properly. We have the same type of system at my work and a couple of people have a program for it on their computer in which they can program the doors and give access to people.
I think its completely unacceptable for there to be one working elevator the majority of the time. This is a 180 unit building, its not that small.
Yeah, it seems like it shouldn't be a hard thing to do. But oh well, at least we can use the gym anytime for now . Speaking of which, I just used the gym and ya, stuck at 23 celsius. Even when it was set to 20, and the fan set to ON, nothing was happening. Got stuffy pretty quick. It MUST be locked at 23 because the fan is set to ON, so at least that should run ... but it doesn't.
I think the other one is just broken.. I haven't seen it for over a month. I dunno when the strike is going to be over, but even when it ends, there is probably a HUGE backlog of work and it may take a while. I think some workers were forced back to work in the GTA, but the priority is buildings with 1 elevator, seniors buildings, high-rises etc. I don't find the one elevator thing too bad the moment...never have to wait more than a minute or so.
What problems are you having with your nest mine works fine?
They had a jumper as the fifth wire according to the manual it isn't needed!
I have v2 it could be when you did the setup and not the install.did u set it up as a gas furnace ? Also I have Y1 as cool (yellow) and W1 as heat (white) , Rc is red for power and G is the green for the fan.